Specification

Technical Data and Specification

NEW Rechargeable Battery Powered Weld Purge Monitor from start to ready

The Argweld ® PurgEye ® 200 IP65 Rechargeable Weld Purge Monitor ® can be used with any Tube, Pipe or Pipeline Weld Purging System, any Flexible Welding Enclosure ® and Weld Purge Chamber. The PurgEye ® 200 can be used for any Weld Purging technique for measuring oxygen levels from 1,000 ppm to 1 ppm (accurate to 10 ppm).

The PurgEye ® 200 IP65 Rechargeable Weld Purge Monitor ® can be used as a continuously reading instrument with free flow of the purge exhaust gas across the sensor, or as a sampling instrument with the integral electro-mechanical vacuum pump.

The Argweld ® PurgEye ® 200 IP65 Weld Purge Monitor ® has been specifically designed to be rechargeable battery power operated or mains power driven. It contains 4 standard rechargeable AA batteries and is supplied with a rechargeable battery unit and charger.

The Argweld ® PurgEye ® 200 IP65 Rechargeable Weld Purge Monitor® has a working temperature between 0 and 70°C (32 and 158°F) and a two minute warm up time.

Note: Use only the weld purge tubing supplied with the Monitor. The leak tight quick fit couplings are specifically integrated so that the user will not have leaks of air into the critical purge zone. Do not use other tubing because it will not fit properly and it may cause leaks. 

The PurgEye ® 200 Weld Purge Monitor ® is shipped in a new, low volume, ergonomically designed, robust carrying, presentation and storage case to maintain the instrument in good condition and to keep it together with all accessories.

Storage Carry Case dimensions: 377 x 322 x 95 mm.
Shipping dimensions: 380 x 100 x 300 mm.
Net weight 2.0 kg.
Volumetric weight with case: 2.28 kg.
Instrument dimensions: 225 length x 115 widest point x 40 mm depth.
Instrument weight: 400 gms (without batteries).

Supplied with:

  • Storage case.
  • 150 mm long red tube to attach to red purge exhaust.
  • 1 metre long green tube with inlet filter.
  • Charging unit for internal batter with mains plug adaptors for all countries.
  • User instruction booklet.

Dew Point SensorDew Point Sensor for accurately measuring the dew point.

During purging welders need to measure the oxygen content but also need to measure the ‘dew point’.

The dewpoint is the temperature where condensation begins and water will condense on the material being welded. This can affect the weld properties significantly.

We have recently added a Dew Point Sensor to our range that can be used in conjunction with our range of 10 ppm Weld Purge Monitors®, so rather than purchasing a separate, expensive Dew Point Meter, HFT®’s Dew Point Sensor that can be connected to the Weld Purge Monitor® via the PurgeNet™ lead.

The dew point sensor is designed to fit any of our Weld Purge Monitors® that read down to 1ppm:

- PurgEye® 200
- PurgEye® Desk
- PurgEye® 600
- PurgEye® 1000
- PurgEye® Site

PurgEye Weld Purge Monitors Oxygen Monitor Gas Analyser Welding Analyzers

Compare all Weld Purge Monitors® in the PurgEye® Family Range

 

Click here to send us a message

Contact us - See our Worldwide Offices